Saw vice

Home-Made Wooden Saw Vise

Home-Made Wooden Saw Vise

Sharpening a handsaw is a prospect every hand tool user has to face sooner or later. If you like restoring old tools (and it can be addictive) it is likely to be sooner. A saw vise makes this task infinitely easier, but saw vises can be expensive and difficult to come across. Thankfully saw vises are very simple pieces of equipment, and you can build a wooden saw vise that sits in your leg vise and is just as effective as the cast iron ones. And it only takes a few minutes.

Homemade saw vise out of wood

Homemade saw vise from wood scraps

All you need is two boards, 10″ or longer and 8″ or wider, and 6 strips of wood around 1/2″ square and 10″ long. Attach a strip of wood using glue or nails along the top and bottom edges of each board, and another strip on the opposite side of each, around an inch or so from the top. The next step is to connect the two bottom strips of wood with a strip of leather so it acts like a hinge, and the vise closes so the two strips of wood on one piece meet the two strips on the other. The only thing left to do is to plane or sand the top strips so that they are slightly concave.

This is important so that when the vise is tightened in your vise, it applies a lot of pressure on your saw plate, reducing vibrations and making sure your saw stays in place. And that’s all there is to it. Place your new saw vise in your leg vise, insert your saw and tighten the leg vise, and file away!

Posted by Prairie Artisan Woodshop in This and That, 0 comments